Keep Your Lamp Burning

Designed by Jeannie Phillips ~ Southside, AL

Click on any picture to enlarge.

The file for this card is available by email... just copy and paste the following email into your own email account.

CRICUT & GYPSY

Sentimental

Lamp its shadows and all 4 or its layers cut @ h 3.56... set the height and the widths will be right... the lamp shadow that isn't in red isn't welded to that small rectangle...its there to cut the right shape out in the rectangle to make the lamp layers sit right...I also liked the effect better.... on the Cricut I would cut these @ 4 inches... I wouldn't worry about the un-welded shadow cut.

Stamp shaped cuts cut @ w 1.46 x h 1.74... on the Cricut I would cut these at 1 3/4 inches.

Give A Hoot

Flourishes cut @ w 2.01 x h 0.65 ... on the Cricut I would cut these at 1/2 an inch.

Forever Young

Lady Silhouettes cut @ w 0.66 c h 1.40.. do not weld this cut to the rectangle behind it...so it will be cut out of the center.... on the Cricut I would cut these @ 1 1/4 inch in black and glue on top of the square.

George

All the rectangles are actually squares cuts with the height and width off to get the sizes I needed.

Squares welded to the lamp shadows and grouped then cut @ w 0.66 x h 1.40...lay out one of these then duplicate so they will be exactly the same... pop the first one from the background... then pop the other from that... using the Cricut I would cut these on my paper trimmer at width 3.5 x h 1 3/4 an inch and then glue the shadow into place.

Smaller Square for the sentiment cut @ w 3.41 x h 1.52...place the lamp shadow over this... in the right place... but do not weld so you get the round cut in the corner...see picture.... to line this up right I placed it over the welded pieced... the grouped and moved...using the Cricut I would cut this on the paper cutter at a little little more than 3 inches x 1 1/2 inches.

Square with the silhouette cut out cut @ w 1.19 x 1.46 ...using the Cricut would cut these with the paper cutter 1/4 inch wider and taller than your stamp cut.

*The lamp shadow that is not welded is placed off the paper some because you don't need that  lamp except for what it does to the square.