Congratulations and Good Luck!

Designed by Jeannie Phillips ~ Southside, AL

Click on any picture to enlarge.

This card was inspired by Anita Chavez's Friend card... click HERE to see hers... I just loved her layout!!... so this  morning I went to work to make my version of Anita's layout... and my daughter, Madison called and needed a Congratulations and Good Luck card... her boss got a promotion... at IP and they are going to miss her so much....so Madison wanted a special card for her... I added extra pages to the inside for people to sign... I so hope that Madison and her work buddies love the card... thank you so much for looking!!! Hugs, Jeannie

CRICUT & GYPSY

Walk in My Garden

Pot (x2) cut @ w 1.86 x h 1.50... I popped one off the other.... on the Cricut I would cut these at 1 1/2 inches.

Daffodil and its layers cut @ h 3.50...set the height and your width will be right on both cuts....on the Cricut I would cut this @ 3 1/2 inches.

Snail and its layer (x2) cut @ h 0.72 ..set the height and the width will be right....on the Cricut  I would cut this at 3/4 and inch.

Ladybug and her layer (x2) cut @ h 0.89 set the height and the width will be right.... on the Cricut I would cut these at 3/4 and inch.

Bee and its layers (x2) cut @ h 1.0  set the height and the width will be right..I cut two base layers  and two top layers for each bee the base layers I cut in velum so I would have two layers of wings...the top layers you need one in black and one in yellow... .on the Cricut I would cut these @ 1 inch.

Easter 2010

Grass

Tall Grass cut @ w w 1.92 x h 1.52...you will have to unlink the width and height to get this size....on the Cricut I would cut this @ 1 1/2 inches.

Shorter Grass Cut @ w 1.92 x h 1.32 ...on the Cricut I would cut this at 1 1/2 inches and trim 1/4 inch off the bottom with my paper trimmer.

George

Small Square cut @ w 1.45 x h 1.36...this will make a perfect square.

Medium Square cut @ w 1.61 x h 1.50.

Large square ...I decided I needed it later and cut it 1/4 inch taller and wider than the medium square on the paper trimmer...which was 1 3/4 inches by 1 3/4 inches.

Using the Cricut I would cut the large square 1 3/4 inches square ... medium square 1 1/2 inches square...and small square 1 1/4 inchs square...with my paper trimmer.

The words were computer generated..then I used my paper trimmer to make the frame and the strip behind the sentiment squares.